aDriv4 - MANAGER

Edit File: :etc:chrony:chrony.conf

# Welcome to the chrony configuration file. See chrony.conf(5) for more # information about usable directives. # Include configuration files found in /etc/chrony/conf.d. confdir /etc/chrony/conf.d # This will use (up to): # - 4 sources from ntp.ubuntu.com which some are ipv6 enabled # - 2 sources from 2.ubuntu.pool.ntp.org which is ipv6 enabled as well # - 1 source from [01].ubuntu.pool.ntp.org each (ipv4 only atm) # This means by default, up to 6 dual-stack and up to 2 additional IPv4-only # sources will be used. # At the same time it retains some protection against one of the entries being # down (compare to just using one of the lines). See (LP: #1754358) for the # discussion. # # About using servers from the NTP Pool Project in general see (LP: #104525). # Approved by Ubuntu Technical Board on 2011-02-08. # See http://www.pool.ntp.org/join.html for more information. pool ntp.ubuntu.com iburst maxsources 4 pool 0.ubuntu.pool.ntp.org iburst maxsources 1 pool 1.ubuntu.pool.ntp.org iburst maxsources 1 pool 2.ubuntu.pool.ntp.org iburst maxsources 2 # Use time sources from DHCP. sourcedir /run/chrony-dhcp # Use NTP sources found in /etc/chrony/sources.d. sourcedir /etc/chrony/sources.d # This directive specify the location of the file containing ID/key pairs for # NTP authentication. keyfile /etc/chrony/chrony.keys # This directive specify the file into which chronyd will store the rate # information. driftfile /var/lib/chrony/chrony.drift # Save NTS keys and cookies. ntsdumpdir /var/lib/chrony # Uncomment the following line to turn logging on. #log tracking measurements statistics # Log files location. logdir /var/log/chrony # Stop bad estimates upsetting machine clock. maxupdateskew 100.0 # This directive enables kernel synchronisation (every 11 minutes) of the # real-time clock. Note that it can't be used along with the 'rtcfile' directive. rtcsync # Step the system clock instead of slewing it if the adjustment is larger than # one second, but only in the first three clock updates. makestep 1 3 # Get TAI-UTC offset and leap seconds from the system tz database. # This directive must be commented out when using time sources serving # leap-smeared time. leapsectz right/UTC